Operating manual for BAUER RAINSTAR series TX Plus 75
22.1 SETTING THE SHIFTING GATE
The shifting gate (8) must be adjusted to the gearbox shut-off point.
Procedure:
Shift the shut-off lever (9) into “PE-pipe retraction” position.
Turn the V-belt pulley (10) – the PTO shaft (11) rotates too.
Slowly shift the shut-off lever (9) to “0” position.
The shut-off point is reached when the PTO shaft no longer turns along. Set the shifting gate in this position
according to the drawing ( 2 mm)!
The spring (12) presses the shut-off lever (9) upward along the incline of the shifting gate and thus also into the
recess provided in the gearbox.
22.2 SETTING THE BAND BRAKE
Tighten the hex. nuts (2) of the band brake until the bolt thread of the brake band (1) projects B =13 mm. At
that the length of the stretched spring (12) A = 144 - 148 mm. Then lock the hex. nuts (2).
Tighten the hex. nut (3) until the spring (5) is pretensioned C = 22mm, lock with nut (4).
To Next Page
Loading...
