Operating manual for BAUER RAINSTAR Series TX Plus 26
6.4 STATUS DISPLAY
STATUS: Status messages in display
EMERGENCY: machine has not been started, speed impulses, however, are being received and it is trying
to maintain the speed requested.
RUNNING: Machine is irrigating, everything is working properly.
LOW PRESSURE: Water pressure is below pressure switch threshold. Machine acts depending on machine
data.
START: Operator has pressed „START“-button and the start sequence is in progress
START REMOTE: Machine is starting due to an SMS.
START DELAY : Machine is waiting for start delay to elapse (see menu 4).
START PRESSURE : Machine has started due to pressure rise. Machine uses pressure level to start 2
nd
machine on string.
START DENIED: Operator is holding „STOP“-button to prevent PRESSURE- and REMOTE start
zu verhindern.
STOP USER: Machine has stopped due to operator STOP.
STOP REMOTE: Machine has stopped due to an SMS.
STOP SENSOR: Machine has reached end and is stopped by STOP SENSOR.
STOP DISTANCE: Machine has reached distance for stop (see constant No. 8 for early stop).
STOP DELAY: Machine has reached stop but waits nn seconds to proceed stop sequence..
STOP DENIED: Operator is pressing „START“-button to prevent REMOTE stop.
SUPERVISION TIME: Machine has stopped due to supervision time is elapsed. Machine has not moved in
nn minutes (see constant for supervision time)
FORCE LOW PRESSURE: Machine opens shut-off valve to force pressure drop in order to stop the pump. After
2 minutes valve closes to prevent draining of pipe.
PRE IRRIGATION: Machine is performing pre irrigation.
POST IRRIGATION: Machine is performing post irrigation.
There are different constants that can be set by the user.
These constants will be saved for years even if the battery is disconnected.
To Next Page
Loading...
