Bauer Rainstar TX Plus Series - Page 32

Operating manual for BAUER RAINSTAR Series TX Plus 24
MENU 5
0m 30.0m/h 0m
0m 30.0m/h 0m
0m 30.0m/h 0m
0m 30.0m/h 0m
In this menu the irrigation can be set and four different retraction speeds are possible.
Press the „PROG“ key three times.
Further details see below.
MENU 6
SIGNAL 23
NETWORK HOME
A: +45123456
B: +45234567
SIGNAL GSM-signal strength
NETWORK GSM-Network type
A: First phone number on the SMS-list
B: Second phone number on the SMS-list.
Detailed description in the chapter GSM.
START:
The turbine can only start if the magnet activates the stop sensor (or stop sensors), see Menu 3 for controlling the
function of the stop sensor. When the „START key is pressed the shut-off valve opens. Next the by-pass valve
closes (the turbine starts). If the magnet does not activate the stop sensor only the shut-off valve opens. This is
used if the pressure should be released before disconnecting the hose at the hydrant.
DELAYED START TIME OF IRRIGATION:
First press „STOP“-key for closing the inlet of water. Next press „MENU“-key 3 times (Menu 4), „PROG“-key 3
times and you can start time. Finally, pre- and post- irrigation can be selected.
STOP:
When the magnet is removed from the stop sensor, the turbine stops and the shut-off valve over-pressure closes
(or if available the shut-off valve low-pressure opens).
If post-irrigation is chosen, the turbine stops and after the post-irrigation time the shut-off valve closes. If the key
„STOP“ is pressed, the turbine stops and the shut-off valve closes, regardless if post-irrigation was selected.
SUPERVISON:
The ECOSTAR 4300 has an integrated supervison system. SUPERVISON is activated if for some reason the
machine irrigates at the same place longer than a specified time. This time is factory adjusted to 20 minutes, see
programming for changing this time. If it set to 0 there is no supervison.
SPEED :
The speed is set with keys „+“ and „ –“, at first the speed changes step by step 0,1 m/h, after 10 steps for 1,0 m/h.
The speed can be changed at any time, even while the machine is running. If the time is checked it shows the new
time for the remaining irrigation.