Bauer Rainstar TX Plus Series - Page 44

Operating manual for BAUER RAINSTAR Series TX Plus 36
MACHINE DATA
Machi
ne.Dat
.
Anm. Facto
ry
settin
gs
Min.
value
Max.
value
Description
0 600 0 1000 Pipe length [m]
1 125 40 200 Pipe diameter [mm]
2 1850 500 3000 Reel diameter [mm]
3 11,27 5,00 30,00 Windings per layer
4 240 50 1000 Big chain wheel
5 9 5 40 Small chain wheel
6 4 1 20 Number of magnets
7 0,89 0,70 1,00 Pipe ovality
8 3 0 45 First impulse to the switch-off motor [Sec.]
9 160 0 300 Short impulses to the shut-off motor [msec]
10 3 1 5 Time between short impulses [Sec.]
11 100 0 250 Number of short impulses
12 0
1
0 1 Shut –off system
0 = only regulating motor turbine ( without shut-off valve)
1 = both regulating motors ( with shut-off valve )
13 8,2
4,1
1 25 Impulses to close the regulating valve [Sec]
TX60 , TX100 - 8,2 sec.
TX20 , TVR 20 , TVR 60, F 30, F 40 - 4,1 sec.
14 0
1
0 2 Pressure switch
0 = Pressure switch not in function
1 = Pressure switch in function
2 = Pressure switch only for start
15 0 0 160.0 62,5 Distance of the impulses with roll Ø 80 at the PE-pipe [ mm ]
0 = works with formula ( Machine. Dat. 0 to 7 )
16 1 0 1 Length sensor
0 = Round sensor for roll
1 = Double sensor
17 0
1
0 1 Open shut-off valve
0 = shut off valve opens with one impulse ( 12 sec. ) –low pressure
1 = shut-off valve opens with the same impulses as it closes -
overpressure
18 0
1
0 1 Pressure switch
0 = shut-off valve open when pressure is too low offen (low pressure )
1 = shut-off valve closes if pressure is too low (overpressure)
19 8 0 200 Time delay shut-off gear to shut-off valve [Sec].
20 0
1
0 1 Speed monitoring
0 = Monitoring off
1 = Monitoring on
21 0
1
0 1 Unit view
0 = metric units [m]
1 = US –unit [ft.]
30 0 0 1 0 = GSM-Modem not active
1 = GSM-Modem
2 = GSM-Modem, only numbers on the SMS-list
31 - - - First telephone number to call „A“
31 - - - Second telephone number to call „B“