Bauer Rainstar TX Plus Series - PE-Pipe Pull-Off Procedure (TX 20)

Operating manual for BAUER RAINSTAR Series TX Plus 66
Pick up the draw-out hook with the toolbar and pull off the
cart.
Pull-off speed: do not exceed 5 km/h!
Do not stop abruptly. Always slow down gradually at an intermediate stop in the field or at the end of the pull-
off. Stop pulling off the pipe when the white marking line becomes visible on the reel.
If the PE-pipe is to be pulled off in a wide bow, make sure that it is pulled in a
straight line of about 80 to 100 m first (90° angle to the reel) and then in a wide bow.
If the PE-pipe has been exposed to the sun for a longer period or if its surface
temperature rises above 35 °C for some other reason, you must let water run
through the pipe to cool it off before the unwinding or retraction procedure.
Couple the pressure hose. Open water supply.
Put the gear shift lever into the correct position.
TX 20
1
8
--
20
m / h
2
16
--
32
m / h
3
28
--
50
m / h
4
> 45
m / h
WARNING!
Warning!