Baur Sys compact 2000 M pro - Setting the Time; Setting the Contrast of the Display; Setting the Brightness of the Indicator Lights

Syscompact 2000 M pro Configuring and operating the system
822-175-2 47 / 98
10.3 Setting the time
Prerequisite
The system is switched on.
Further information: Chapter Switching on the system (on page 40)
Procedure
1. Press the MENU key on the display.
2. Select the INSTRUMENT SETTING menu item and press the ENTER key.
3. Select the TIME menu item and press the ENTER key.
4. Adjust the time and press the ENTER key.
10.4 Setting the contrast of the display
Prerequisite
The system is switched on.
Further information: Chapter Switching on the system (on page 40)
Procedure
1. Press the MENU key on the display.
2. Select the INSTRUMENT SETTING menu item and press the ENTER key.
3. Select the CONTRAST menu item and press the ENTER key.
4. Select the desired contrast and press the ENTER key.
10.5 Setting the brightness of the indicator lights
Prerequisite
The system is switched on.
Further information: Chapter Switching on the system (on page 40)
Procedure
1. Press the MENU key on the display.
2. Select the INSTRUMENT SETTING menu item and press the ENTER key.
3. Select the SIGNAL LAMP menu item and press the ENTER key.
4. Set whether the indicator lights should be 50% or 100% illuminated and press the ENTER
key.