Baur Sys compact 2000 M pro - Maintenance Schedule; Checking the Ignition Voltage of the Spark Gap

Maintenance and care Syscompact 2000 M pro
80
/ 98 822-175-2
15.2 Maintenance schedule
Interval Task
After each use  Check and clean the connection cables and the connection
accessories.
Further information: Chapter Checking and cleaning the connection
cables and accessories (on page 83)
Monthly  Check the condition of all connection cables.
Further information: Chapter Checking and cleaning the connection
cables and accessories (on page 83)
Every 12 months
(with frequent use, every 6 months
or as required)
 Check the discharging resistance of the discharge unit.
Further information: Chapter Testing the discharge unit (on page 82)
Every 12 months
(with frequent use, every 6 months
or as required)
 Check the ignition voltage of the spark gap.
Further information: Chapter Checking the ignition voltage of the spark
gap (on page 80)
As required depending on the
conditions of use
 Clean the system components.
Further information: Chapter Cleaning system components (on page
84)
As required  Replace the IRG 2000 rechargeable batteries.
Further information: Chapter Replacing the rechargeable batteries of
the IRG 2000 (on page 85)
15.3 Checking the ignition voltage of the spark gap
 Check the ignition voltage of the spark gap every 12 months or as required. The ignition
voltage must be between 500 and 1000 volts.
Procedure