To Next Page

To Previous Page

17.6Automaticreset

1.IfaflashingspannerisshownontheTHINKControllertheerrormayresetoncetheconditionhascleared.Manyoftheseautomaticreseterrorsareconnectedwith

temperaturesensorsofboththesystemandtheapplianceandoncetheappliancehascooleditmayrestart.Iftheproblempersistswherethesameerrorcodeis

repeatedlydisplayedortheerrorwillnotclearyoushouldcallforaserviceengineer.

17.7Userreset

1.AuserresetcanonlybecarriedoutontheTHINKControlleror5LEDReceivernotonaroomsensor.

2.Toperformauserreset:

a)onthe5LEDReceiver,presstheresetbuttonatthebottomoftheReceiver,afterafurther6flashestheredLEDwillgoout.

b)ontheapplianceTHINKController,fromthestandardscreenpresstheSelectorButtontwice,afterafewsecondstheerrorsymbolshoulddisappear.

3.Theerrorwillclearandtheappliancewillrestartifthereisademandforheataslongastheerrorconditionhascleared.

4.Iftheerrorreturnsthefaultconditionisstillpresent.

17.8Servicereset

1.Whenaflashingspannerisaccompaniedbyacrossedoutflamesymbolontheappliance,afaulthasoccurredwhichrequiresthepresenceofaserviceengineer.When

ringingtheHeateamServiceDepartmenttorequestaserviceengineerpleasequotetheerrorcodeandaccompanyingmessagealongwiththeserialnumberofappliance.

page80

2.AServiceresetshouldonlybecarriedoutbyaserviceengineeraftermakinganoteoftheerrorcode.Untrainedpersonnelwhoperformaserviceresetmayvoidthe

warranty.