Baxi POWER HT+ Series - Starting up the Boiler; Stopping the Boiler; Putting the Boiler in Standby Mode

3. Select the C
Commissioning
menu by turning the button.
4. Confirm the menu selection by pressing the button
.
Note
Press the
MENU
key to return to the main display.
The C
Commissioning
mode parameters are now accessible. Use the
button to select and modify them.
See
List of installer parameters, page 74.
8.2 Starting up the boiler
1. Start up the boiler by pressing the ON/OFF switch.
2. Open the gas cock.
3. Press the
key to access the shortcuts menu.
4. Select the S
Standby/operation
parameter by turning the button.
5. Press the
button to start up the boiler.
The
symbol disappears.
8.3 Stopping the boiler
Note
Prefer the O
Off
or S
Standby
operating mode.
See
Activating Protection mode, page 70
Putting the boiler in Standby mode, page 69
1. Switch off the boiler by pressing the ON/OFF switch.
2. Close the gas cock.
8.3.1 Putting the boiler in Standby mode
1. Press the key to access the shortcuts menu.
2. Select the S
Standby/operation
parameter by turning the button.
3. Press the
button to put the boiler in standby.
The
symbol is displayed.
Fig.73
MW-3000083-EN-02
MENU
---------------------------------------------------
-
Enduse
r
Commissionin
g
Fig.74
MW-3000084-EN-02
MENU
Enduse
r
Commissionin
g
En
g
inee
r
Fig.75 Starting up the boiler
MW-3000050
1
8 Operation
7609474 - v02 - 04092014 69