Baxi POWER HT+ Series - List of Installer Parameters

Tab.45 Temps / mode CH1 – Temps / mode CH2 – Temps / mode CH3 menu
Parameter number Parameter Description Factory setting
Heating
circuit 1
Heating
circuit 2
Heating cir
cuit 3
700 1000 1300
Operating
mode
The control unit is installed on the boiler:
Off : heating is deactivated.
Timed : the heating is dependent on the timer pro
gram.
Reduced : heating is in permanent reduced mode.
On : heating is in permanent reduced mode.
The control unit is installed as a room temperature
control system:
Off : the boiler starts up when the room tempera
ture falls below the frost protection set point.
Timed : the heating is dependent on the timer pro
gram.
Reduced : the room temperature set point is the
reduced set point (Parameters 712, 1010, 1310)
On : the room temperature set point is the comfort
set point (Parameters 710, 1010, 1310)
On
710 1010 1310 Comfort
setpoint
20 °C
712 1012 1310 Reduced
temp setpoint
16 °C
10.1.4 List of installer parameters
Tab.46 Structure of the installer menu
Menu Sub-menu
Installer Operator section
Temps / mode CH1
Temps / mode CH2
Temps / mode CH3
Temps / mode hot water
Boiler Settings
Solar
Configuration
Error
Service/special operation
State
Diagnostics heat generation
Burner control
Tab.47 Operator section menu
Parameter
number
Parameter Description Factory set
ting
24 Lighting Off
Temporarily
Permanently
Temporarily
29 Units °C, bar
°F, PSI
°C, bar
10 Settings
80 POWER HT + 7702630 - v02 - 11082018