baxter PCA II - Inserting Batteries into the Pump

Setup
Inserting Batteries into the Pump
The pump requires 4 D-cell alkaline batteries, or the optional
AC power kit.
For detailed information about operating the AC Power Kit, refer
to The AC Power Kit section in this manual.
To insert the batteries:
s Turn che pump upside down, as shown in Figure 2-1.
По
Figure 2-1 ° Battery compartment
* Push in and slide open the battery compartment cover.
* Insert the battertes with positive ends toward the opening.
s Close the compartment cover by pushing it in and sliding it
under the edge of che pump case.
IMPORTANT | fmproper installation of batteries may cause batteries to leak.
VA