baxter PCA II User Manual

Setup
Priming the Tubing Set Press [1]
to prime,
Prime che tubing set, as follows. Lor
. close and
e With che cover open and unlocked, Lock cover...
hold down the [1] key. to continue. .
The drive motor advances the syringe plunger for a maximum
of2 mL.
+ Repeat until fluid appears at the end of the tubing ser.
Make sure all air is removed from the tubing set before attaching
it to the patient. Refer to the instructions included with the
tubing set for proper priming instructions.
WARNING
When using a Prefilled Syringe, an appropriate Anti-Siphon Set
or Prefill Combination Y-Set must be used. This will help prevent]
uncontrolled siphoning due to damage or incorrect placement of
the Prefilled Syringe.
When the PCA H Pump is used with a primary IV line, use of an
appropriate Y-Set is highly recommended. Failure to properly use
a Y-Set may result in retrograde analgesic flow into the primary
line during a partial or complete downstream occlusion. This
may subsequently result in inadvertent bolus to the patient when
the occlusion is cleared.
Use of an appropriate tubing set with a tamper resistant disk is
highly recommended to ensure the integrity of the drug stored in
the syringe.
To reduce the risk of a bolus being infused afier an occlusion has
occurred, the pressure must be relieved by resetting the pusher
block andlor disconnecting the system prior to freeing the occlu-
sion. To minimize the bolus volume, use disposable sets spe
cally designed for PCA pumps.

baxter PCA II Specifications

General

Brand	baxter
Model	PCA II
Category	Water Pump
Language	English