baxter PCA II User Manual

i
Routine Maintenance
Cleaning and Disinfecting
The exterior surfaces may be cleaned using a cloch dampened
with water or a mild detergene, then wiped dry. A mild
germicide may be used as a disinfectant. Baxter Anesthesia
recommends Vestal,© LPH® germicide, or equivalent.
CAUTION The PCA II Pump is not waterproof and should not be
immersed. Avoid getting liquide inside the pump or
permanent damage may result. Do not use alcohol for
cleaning. Sterilization by ETO, steam, or other method
should not be attempted.
The sets that are used in the PCA I pump are disposable
and intended for single use only.
Lubrication
The lead screw should be lubricated at least every six months
using General Electric® Versilube® G-322L grease. Using the
nozzle applicator supplied with the grease, squeeze a small
amount onto the entire length of the lead screw. Do this by
carefully inserting the nozzle straight into the case channel
thereby spreading the rubber seal. Use care to avoid damaging
the seal.
CAUTION Use only the recommended lubricant. A substitute lubricant
may cause permanent damage.
Vestal and LPH are registered trademarks of Vestal Laborarories, Inc.
a subsidiary of Chemed Corporation. General Electric and Versilube
are registered trademarks of General Electric Company.

baxter PCA II Specifications

General

Brand	baxter
Model	PCA II
Category	Water Pump
Language	English