baxter PCA II User Manual

Attaching the Pump to the IV Pole
The pump is designed to be attached to an TV pole. Use the
clamp to attach the pump to the TV pole, as follows.
* Attach the clamp to the pump:
Make sure the arrow on the clamp is pointing upwards, as shown
in Figure 2-2.
Figure 2-2 + Attaching the pump to the IV pole clamp
—Align the IV pole mounting clamp with the slide bracket on
the back of the pump.
— Slide the clamp coward the top of the pump until the pump
can go no further.
e To attach the clamp permanently to the pump, insert the two
screws-— supplied with the pump— through the clamp into
the holes in the bracket.
* Mount the IV pole clamp to the IV pole or to a rail ranging
from 1/2-inch to 1 1/4-inch in diameter and tighten it.

baxter PCA II Specifications

General

Brand	baxter
Model	PCA II
Category	Water Pump
Language	English