baxter PCA II User Manual

Power-up
Correct action:
The self-test message
appears briefly and che
pump beeps.
Attention light
Correct action:
‘The red light flashes
whenever a prescription
has been entered and is not
running or the syringe
cover is open.
Pusher block
Correct action:
The syringe holder snugly
holds a syringe. The pusher
block moves frecly over the
complete travel range.
The anti-siphon latch of the
pusher block captures the
syringe plunger to prevent
siphoning.
Routine Maintenance
+ Press the ON button.
© Check to make sure the cartridge is properly
seated in its slot.
* IFan electronic fault alarm appears, record the
error number, (or, if the pump beeps continuously
with no message) turn the pump OBE
* Disconnect the pump from the patient and return
the pump for service.
© Push and turn the key to the UNLOCK position.
* Open the syringe cover.
s IFan electronic fault alarm appears, record the
error number and turn the pump OFF.
+ Disconnect the pump from the patient and return
the pump for service.
¢ Insert syringe in pump, but do not connect pusher
block to syringe plunger.
+ Close and lock the cover.
« Enter and verify the prescription.
e The Pusher block not connected message should
appear.
+ Unlock and open the cover.

baxter PCA II Specifications

General

Brand	baxter
Model	PCA II
Category	Water Pump
Language	English