baxter PCA II User Manual

The AC Power Kir
No Batteries
If there are no batteries in the pump while using the charger,
the No Batteries message will be displayed. Rechargeable
batteries should be inserted into the pump. Disconnecting the
charger will cesult in termination of pump operation:
Repaiv and Troubleshooting of the AC Power Kit
Refer to the chart below for the problem and possible solution.
IMPORTANT | There ave no internal user repairable parts or adjustments.
Contact your Baxter Anesthesia sales representative if the j
charger or rechargeuble batteries
Problem.
Possible
Solution
‘The Battery Power | * Make sure the charger is properly connected to the
message remains pump. ーー
when the charger is
plugged. in. Make sure the charger is plugged into the AC outlet.
Make sure the AC outlet has power.
Try the charger on another pump. If it fails on the
pump that is known to operate properly, the charger ， i
should be replaced. M
Try a different charger on the same pump. If the 。
pump still does not operate properly, it should be i
returned for repair.

baxter PCA II Specifications

General

Brand	baxter
Model	PCA II
Category	Water Pump
Language	English