baxter PCA II User Manual

The AC Power Ki
Operating Notes
The pump should be connected to the charger whenever
possible to keep the rechargeable batteries at full power. When
the pump is to be temporarily disconnected from AC power, it
is
recommended that the charger be unplugged from the pump
and left connected to the AC outlet.
The pump operates the same on either AC or DC power with
the exception of the following messages.
Battery Power
Whenever the pump switches to battery backup power— either
as a result of unplugging the charger or a power failure— the
pump will beep three times and display the Battery Power
message. ‘Ihe message remains as long as the pump continues
to draw power from the backup batteries, and the batteries are
nor running low on power.
If the Battery Power message appears unexpectedly, check to see if
the charger unit has been accidently disconnected from the AC
outlet.
Insert Charger
If the rechargeable batteries start to run low, the pump will
beep and display the Insert Charger message.
* Press CLEAR to temporarily silence the alarm.
+ Plug io the charger as soon as possible.
The pump will continue ro operate for approximately 1 hour
after the message first appears. The message remains on the
screen as long as the pump continues to draw power from the
backup batteries
Battery Power
Insert Charger
in pump operation.
IMPORTANT | Failure to plug the charger in prompily once the Insert
Charger message has appeared may result in an interruption

baxter PCA II Specifications

General

Brand	baxter
Model	PCA II
Category	Water Pump
Language	English