baxter PCA II - The AC Power Kit; Setting up the AC Power Kit

The AC Power Kit
The AC Power Kit
The AC Power Kit powers the PCA II Pump with AC power
from a wall outlet; it is an alternative to using 4 D-cell alkaline
batteries. The kit consists of:
2 TAC charger
+ 2 rechargeable nickel cadmium batteries
This section includes information about setting up the AC
Power Kit, operating notes, a repair and troubleshooting guide,
and AC Power Kit specifications.
Setting Up the AC Power Kit
Setting up the AC Power Kit involves inserting the batteries,
plugging the charger into the pump, and plugging the charger
into a wall outlet, as described in detail below.
* Insert the rechargeable batteries into the pump, as follows.
-—Turn the pump upside down.
一 Push in and slide open the battery compartment cover.
IMPORTANT | Jfnon-rechargeable barteries have been previously installed in the
pump, they must be removed and replaced by the rechargeable
nickel cadmium batteries.
Do not mix rechargeable with non-rechargeable batteries under
any circumstances. Doing so may result in damage to the pump.
—Insert the rechargeable batteries with. the positive end
towards the open end of the battery compartment.
—Close the compartment cover.
* Arrach the pump to the IV pole, if desired.
For details about attaching the pump to the 1V pole, see Attaching
the Pump to the IV Pole in this manual.