BA series pumps
Warnings and safety instructions 1401
3.2
It is not permitted to tow a pump unit fitted with wheels and a tow bar on public roads. These features
are only intended for moving the pump unit within the site.
3.3 Safety instructions – pump
Do not exceed the limit values of the pump curves. See the specification sheet for the pump concerned.
Make sure that hot/cold and rotating parts of the pump are shielded adequately to prevent unintentional
contact.
It is not permitted to start the pump if such guards are missing or damaged.
The company management must ensure that everyone who works with/on the pump or pump
installation is aware of the type of liquid that is being pumped. These persons must know what
measures are to be taken in the event of leakage.
Dispose of any liquids that have leaked, in a responsible manner. Observe local regulations.
If pumping liquids with a temperature of 70 °C (158 °F) or higher, the hot surfaces of the pump and
piping must be shielded.
Apply ‘hot surface’ warning symbols.
If volatile and/or hazardous liquids are being pumped, the hazards of these substances must be taken
into consideration when performing work on the pump or pump installation. Make use of personal
protective equipment and provide sufficient ventilation.
Never allow a pump unit with a drive power in excess of 11 kW (14.7 hp) to run with a blocked pressure
line. The heat build-up could lead to an explosion.
WARNING
It is not permitted to pump volatile or hazardous substances with BA series
pumps.Contact BBA Pumps if you wish to pump such liquids.
3.4 Safety instructions – electrically driven pump unit
The electrical system must be in compliance with the regulations of the local electricity producer and
the EN 60204-1 standard.
The electrical system to which the pump unit is connected must be equipped with a reliable safety
circuit.
If the electrical system is deficient in any way, the pump unit may not be started.
To Next Page
Loading...
Need help?
General
