BA series pumps
Pump unit with diesel drive 1401
8.10
8.7 Stopping
1. Turn the switch on the control panel to position (1).
2. Observe whether the system comes to a gradual, smooth stop.
3. Perform the general steps for shutting down the pump (see chapter 7).
8.8 Diesel drive engine unit – Hatz
The following information has been reproduced from the Hatz documentation with the permission of
Hatz.
Important notes on safe operation of the engine
HATZ diesel engines are economical, strongly built and long-lasting. They are therefore frequently
chosen for commercially and industrially operated equipment and machinery.
Since the engine forms part of the finished equipment or machine, its manufacturer will take all the
applicable safety regulations into account.
Nevertheless, we give below certain additional comments on operating safety, and would recommend
you to note them carefully.
Depending on the manner in which the engine is installed and its intended application, the equipment
manufacturer or operator may have to attach additional safety devices and prohibit potentially
hazardous aspects of operation, for example:
– Parts of the exhaust system as well as the surface of the engine are of course hot during operationof
the engine, but also when it is still cooling down after use, and must not be touched.
– Never run the engine in closed or badly ventilated rooms.
– Do not breath in emissions - danger of poisoning!
– Also fuel and lubricants could contain poisonous components. Please follow the instructions of the
mineral oil producer.
– Stop the engine before performing any maintenance, cleaning- and repair work.
– Stop the engine before refuelling.
– Never add fuel near a naked flame or a source of sparks.Don’t smoke. Don’t spill fuel.
To Next Page
Loading...
Need help?
General
