BA series pumps
1401 Pump unit with diesel drive
8.9
7. Set the fuel selection handle in the desired position,
if present.
8. Make sure there is sufficient fuel in the selected fuel
tank.
9. Bleed the fuel system, if necessary.
10. Perform the general steps for starting the pump (see
chapter 7).
11. Close the earth switch (2), if present.
12. Select the desired operating mode with the switch
on the control panel.
Continuous operation
Turn the switch on the control panel to the left (position 2).
Due to the built in start-up delay, it may take a moment before the motor
actually starts.
Level protection
Turn the switch on the control panel to the right (position 3).
The pump will cycle on and off depending on the level of the liquid being
pumped.
Note
The pump must always be at a complete standstill when the position of the
switch is changed.
To Next Page
Loading...