BA series pumps
Pump unit installation 1401
5.3
– Install shields to prevent contact with hot surfaces > 70 °C (158 °F). Affix warning symbols where
necessary.
– If the pump and motor are provided separately, check the alignment after installation.
– When pumping hot liquids make sure there is sufficient air circulation to prevent bearings and
lubricants from overheating.
– Connect an electrically driven pump unit in conformance with local regulations. The cables must be
dimensioned in accordance with the specifications.
– For placement of an electrically driven pump unit, see also
chapter 8 ‘Pump unit with electric drive’.
– For placement of a diesel engine driven pump unit, see also chapter 9 ‘Pump unit with Perkins diesel
engine drive’.
– Install the prescribed safeguard(s) in the correct manner.
The pump unit can be fitted with safeguards for the following parameters:
• temperature
• overpressure
• under pressure
• direction of rotation
• oil level
• overload
To Next Page
Loading...
Need help?
General
