BA series pumps
1401
i
Introduction
This user manual contains information for the installation, use and user maintenance of a
pump from the BA series. The information in this manual must therefore be strictly
followed. Read and understand the manual completely before installing and
commissioning the pump.
Contact BBA Pumps BV if you have any questions or anything is unclear.
BBA Pumps cannot be held responsible for accidents and/or damage that result from
failure to follow the guidelines in this manual.
Keep this manual with the pump. You can order an extra copy of the manual from BBA
Pumps BV.
This manual is part of the pump. If the pump is transferred to another user, this manual
must accompany it.
Depending on which drive motor/engine is used, this user manual may be accompanied by
the manual for the drive motor/engine. Read the supplied manual carefully and follow the
procedures and safety instructions.
Version and application
The BA series consists of different types of pumps in various versions. The pump is
available as a separate component or as a complete installation. The complete pump unit
can be driven by an electric motor or diesel engine and can be mounted on an open frame,
on a half-closed frame or in a noise attenuating enclosure. From this point forward we
simply refer to an enclosure. For movement around the site, the pump frame can be
equipped with wheels and a tow bar.
The pumps are suitable for pumping clean and polluted liquids.
If the pump is equipped with a vacuum system, the pump is also self-priming.
Note
Because the BA series consists of a large number of different types of pumps in various
versions, the illustrations in this manual may not match the actual situation.
To Next Page
Loading...
Need help?
General
