BA series pumps
1401 Pump unit with diesel drive
8.39
Group 4 Biodiesel
Biodiesel is a fuel that can be defined as mono-alkyl esters of fatty acids. Biodiesel is a fuel that can be
made from a variety of feedstock. The most commonly available biodiesel in europe is Rape Methyl
Ester (REM). This biodiesel is derived from rapeseed oil. Soy Methyl Ester (SME) is the most common
biodiesel in the United States. This biodiesel is derived from soybean oil. Soybean oil or rapeseed oil
are the primary feedstocks. These fuels are together known as Fatty Acid Methyl Esters (FAME).
Raw pressed vegetable oils are NOT acceptable for use as a fuel in any concentration in compression
engines. Without esterification, these oils gel in the crankcase and the fuel tank. These fuels may not
be compatible with many of the elastomers that are used in engines that are manufactured today. In
Territory Fuel Requirements from 2007
EPA Low Sulfur (500 ppm) maximum
EC Sulfur/ Power Low sulfur (300 ppm)
maximum for less than
or equal to 19 kW
Sulphur (1000 ppm)
maximum for greater
than 19 kW
Models 402D-05 and 403D-07 403D-11,
403D-15,
403D-15T,
403D-17,
404D-15.
404D-22,
404D-22T
and
404D-22TA
Non- Regulated
Terr itori e s
Sulfur limit of less than 4000 ppm
Territory Fuel Requirements from 2010
EPA Ultra Low Sulfur (15 ppm) maximum
EC Sulfur/ Power Ultra Low sulphur (10
ppm) maximum for less
than or equal to 37 kW
Low sulphur (300 ppm)
maximum for greater
than 37 kW
Models 402D-05,
403D-07,
403D-11,
403D-15,
403D-15T,
403D-17,
404D-15
404D-22,
404D-22T
and
404D-22TA
Non Regulated
Terr itori e s
Sulfur limit of less than 4000 ppm
To Next Page
Loading...
Need help?
General
