BBK DK1410SI - Parental Control; Initial Setup Menu; Reset to Defaults; Exit Settings Menu

# Default option: Off.
#
#
#
#
#
#
#
Default option: Off.
2.Background: selection of an image as TV
screen wallpaper.
Options: Standard, Saved
Default option: Standard.
3.Screen saver: Screen saver on/off.
Options: On, Off.
Default optioon: On.
4.Jog Dial
Options: Zoom, Step, Skip, Volume.
Default: Zoom.
2.3.8 Parental control
1.Category: Setup of age restrictions to prevent
children from seeing undesirable discs.
Options: Any, Kid, G, PG, PG-B, PGR, R, NC-
17
Default option: Any.
#
#
2.Set password: Setup of a four-digit password
to change the level of age restrictions.
Default option: 7890.#
2.3.9 Initial setup menu
Press the RIGHT key of the cursor joystick to
enter the initial setup menu, then select the
desired item using the jog Dial and press OK
key for confirmation.
While being in this menu section, you cannot
return to the previous level by pressing the
LEFT key of the cursor joystick.
#
#
2.3.10 Reset to defaults
Resetting all settings and restoring default
options, except age restrictions level and
password.
2.3.11 Exit settings menu
Select the item using the jog Dial and press the
OK to exit the menu.
#
2.3.12 Channel delay set-up
Set-up of tine delay in the surround
channel
Usually, time delay in the Dolby Digital
decoding system is preset to ensure best offect
while installing the Hone Theater. However, in
case y you with to adjust your system more
precisely, please consult instructions given in
this manual. Set up of time delay for this device
is possible in both Dolby Digital and Dolby Pro
Logic modes.
Fig.1.Take into account the
A-B distance; use both
figures for setting the
desired time delay.
To set the desired delay you have to know
the distance from the place where you are to the
front speakers and surround speakers as shown
in Fig.1: Consult Fig.2(Dolby Por Logic mode)
and 3(Dolby Digital mode) in order to determine
the distance to Surround Speakers(axis Y in the
figure) and the distance to the front
speakers(axis X in the figure). Crossing point of
those tow Lines on the chart will give the
recommended delay value.
- 11 -