CAUTION
This device has been type tested and found to comply with the
limits
for ISM-Equipment in accordance with the requirements for
FCC Part 15 Subpart J, Class A and EN 5011, Class B, which are
designed to provide protection against such interference in a
residential installation. If the equipment is not used in strict
accordance with the manufacturer’s instructions, it may cause
interference to radio and TV reception or the functionality of other
electrical devices.
NOTE
If it is necessary to inter
rupt operation of the instrument, press the
STOP key on the user interface of the BD PrepMate™ Automated
Accessory.
Introduction
11
1.6.3 Electrical hazards
The same precautions considered when using any ele
ctrical equipment should be observed with
this instrument.
The following warning statement is located on the back of the instrument.
Figure 3 – Voltage warning label
The rear panel power cord inlet (see Figure 2) is considered the main disconnect for the
To Next Page
Loading...
