Local Alarm Setup Procedures
Setting up the Local Alarm involves the following procedures:
• Labeling (see “Local Alarm Labeling” on page 1–129)
• Powering on (see “Local Alarm Power-Up” on page 1–132)
Local Alarm Labeling
Tools required: Phillips head screwdriver
Labels (provided)
1. If the labeling for the Local Alarm was not completed during the installation,
complete it now.
2. To aid in the labeling process, you may want to complete the following table.
Table 1-32. Local Alarm Input Signal Data
Input Number Input Source Alarm Message
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
MedPlus TotalAlert® Alarm Network Operation and Maintenance Manual (205728) Page 1-129
Local Alarm Setup Procedures
Chapter 1: Introduction
1
To Next Page
