73
CD mode
Temperature protection circuit
To protect the laser diode from exces-
sive heat, a temperature protection cir-
cuit is integrated into the unit.
When the temperature threshold of this
protection circuit is activated, the fol-
lowing display is given for 8 seconds.
The unit switches to the operating mode
selected before CD mode was activated.
After a cool down period, the CD mode
may be called up again. If the tempera-
ture is still too high, the unit will once
again switch back to the previously se-
lected signal source.
Notes on CD-R and CD-RWs
You can play CD-Rs (writeable CDs)
and CD-RW (rewritable CDs) on this
unit, but please comply with legal re-
strictions. These restrictions may vary
from one country to another.
Depending on the recording device used
to record the CD-R/CD-RW and / or the
CD-R/CD-RW itself, it may not be pos-
sible to play some CD-Rs/CD-RWs on
this unit.
CD-Rs/CD-RWs must be manufactured
according to the “Red Book” standard
(not applicable for MP3 CDs).
Notes on copy-protected CDs
In some cases, problems may arise when
attempting to play copy-protected CDs,
such as long reading times or a total ina-
bility to perform playback.
To Next Page
Loading...
