Becker Mexico Pro 7930 - Technical Data

98
Technical data
Technical data
• Wavebands:
FM 87.5 MHz - 108 MHz
MW 531 kHz - 1620 kHz
LW 153 kHz - 282 kHz
SW 5800 kHz - 6250 kHz
• Frequency range:
20 Hz - 20 kHz for CD-mode
30 Hz - 15 kHz for FM
50 Hz - 2.5 kHz for MW, LW, SW
• Output:
4 x 18 Watt
• Line cross section:
0.75 mm² min.
• Loudspeaker impedance:
min. 4 Ω
• Line out:
4 x analog Line Out (Va max 3Veff at
10 kΩ)
• GAL:
In order to utilise the GAL, a square
wave voltage with a mass-related am-
plitude of +4 V to +12 V must be pro-
vided by the vehicle’s electronic
speedometer. Volume is increased in
7 increments of 2.5dB each.
• Antenna:
Impedance 50 Ω
• AF telephone input:
Max. input voltage 8 V (if interference
occurs, a commercially available 1 : 1
repeater should be connected into the
signal cable).
• AUX input:
16 KΩ Input resistance, max. input
voltage 1.7 Veff
• Telephone mute:
Low active level < 2 Volt
• Supply voltage:
12 Volt
• CD Connection:
Becker Silverstone 2630, Silverstone
2660 and Silverstone 7860 CD chang-
ers can be connected.
• Playable CDs:
Only CDs which comply with DIN
EN 60908 can be used. The use of
8 cm CDs with an adapter is not rec-
ommended