GB Sound speed controller SFR-1
54 BEIER-Electronic 06.02.2019
To obtain a more realistic driving sound a speed-dependent increase of volume can
be activated with "Increase volume at topspeed". The volume of the driving sounds
will be louder, the faster the model drives. In standing position the volume is
automatically by this percentage less! Therefore, we recommend selecting a low
value at this setting.
Battery voltage monitoring
You can set your battery type and the thresholds for charging the battery and
undervoltage alert here. Additionally you can choose, whether the sound playback
should be stopped and/or the switching outputs should be switched off at
undervoltage.
Multi function
Up to 3 functions can be assigned to each of the 4 multi functions. Using the multi
function 3 functions can be activated at the same time, using only one position at the
transmitter.
For instance: You would like to activate a searchlight and at the same time a servo
sequence should be activated as well. This servo sequence controls a servo, which
moves the searchlight. Without the multi function you would need 2 functions,
triggered at the transmitter:
a. Output x on
b. Servo sequence x on
Using the multi function you can activate at the same time both, the output and the
servo sequence by triggering only one function at the transmitter.
WAV-Player
The WAV-Player setting can be configured here. You can choose whether the next
track should start automatically after finishing the previous track or the playback
should stop.
To Next Page
Loading...
