Beijing TX Series - Custom Tare Command

TX-1xx Series Printer Operation Manual
~ 121 ~
11.4 Custom Tare Command
When the “Auto Tare” feature is enabled, or in the “Tare, Gross, Net weight”
mode, the printer needs to send a tare command to the scale. This parameter is
used to set the specific content of the command. The format of the parameter is
hexadecimal (HEX), for example: assuming the tare instruction of the scale as
follows:
T
CR
LF
The corresponding hexadecimal code is as follows:
54
0D
0A
Then this parameter needs to be set to 540D0A, as shown below:
→ [OK] -> [N/CN] or [DATE] →