TX-1xx Series Printer Operation Manual
~ 40 ~
7 Operating Modes
7.1 Direct Mode
Under this mode, the data from scale would be printed directly.
This mode is usually used in the following scenarios:
➢ Print the calibration report output by the scale. This is because the
calibration report needs to be output as is, but in other modes, the printer
will automatically add other information or filter out the data except the
weighing data.
➢ When you want the scale to decide the output report format.
➢ When a problem occurs in other modes, switch to the Direct mode
temporarily and observe the original data to facilitate analysis and solve the
problem.
Operation:
1. Refer to Section 6.8 and select the “Direct mode”.
2. Press the print key on the scale or the [PRINT] key on the printer.
To Next Page
Loading...