TX-1xx Series Printer Operation Manual
~ 123 ~
Tare 100.000 kg
This parameter is used to filter specific content in the data transmitted by the
scale. For example, suppose the scale outputs the following data:
+ 100.00 kg S
This data does not comply with the No.1 rule above, which will cause the printer
not to recognize this data as weighing data, and it will not work in modes other
than the Direct mode. In order for the printer to recognize it as weighing data, it
is necessary to filter this string, at this time, you can set this parameter to “S”, as
below:
→[OK] -> [N/CN] or [DATE]
→
If you want to filter multiple strings in the data, you can enter it with a comma
separator. For example, the following setting will filter "S" and "Net" in the
data.
To Next Page
Loading...