TX-1xx Series Printer Operation Manual
~ 15 ~
install the ribbon.
Place the printer facing towards you, first, put the Ink ribbon cartridge on the
gear shaft on the left side of the mechanism, uplift the right side slightly, if the
left side of the Ink ribbon cartridge does not reach the bottom, press the knob of
the ink ribbon cartridge and rotate it slowly towards the direction shown by the
arrow. Once the left side reaches the bottom then press the right side hard to
reach the bottom too. Check if the Ink ribbon cartridge is installed correctly.
Rotate the knob if the ribbon is bent or outside of the Ink ribbon cartridge, press
the [Back] key to flatten and tighten the ribbon and to feed the paper into the ink
ribbon cassette. Place the front cover back then the installation is completed.
Note：
The installed ribbon should be in the front of paper, otherwise the printer
wouldn’t be able to print. To avoid this problem, we suggest you to install the
Ink ribbon cartridge first before installing the printing paper.
If belt core of ribbon with wrinkles, please pull the ribbon out, and then rotate
the pinion to tighten ribbon, ensure the belt core is flat.
To Next Page