BHT-206L4-MM-1
5-00-00
25 FEB 2011 Rev. 13 Page 65
ECCN EAR99
Chapter 96 ELECTRICAL
1. Examine all electrical components, wires, cables, and
connectors in the area of the aft deck for chafing, and general
condition and security.
ZONE 6 — TAILBOOM
Chapter 11 PLACARDS AND MARKINGS
1. Examine the placards, decals and markings. Ensure they
are readable, correctly applied and in agreement with the
applicable configuration of your helicopter.
TAILBOOM STRUCTURE
Chapter 53 1. Remove and examine tail rotor driveshaft cover, and
fasteners for condition and security.
2. Remove and examine tail rotor gearbox fairings for
condition.
3. Examine anti-chafing adhesive tape (C-460) on tailboom
for condition. Replace worn or damaged tape as required.
In the event that cracks are found, contact Bell
Helicopter Textron, Product Support Engineering.
4. Examine entire tailboom for the following conditions:
a. Dents.
Pay particular attention to the upper left side tailboom
quadrant.
b. Cracks.
c. Deformation.
5-24. 300-HOUR AIRFRAME PROGRESSIVE INSPECTION — EVENT NO. 4 (CONT)
DATA REFERENCE INSPECTION TASK DESCRIPTION
INITIAL
MECH OTHER
To Next Page
Loading...
