BHT-206L4-MM-1
5-00-00
Export Classification C, ECCN EAR99
9. Ensure no sealant voids are visible around forward and aft
nodal beam deck mounted supports and isolation mount.
Recoat with sealant (C-308) as required.
MAIN DRIVESHAFT
Chapter 63 1. Examine the engine to transmission driveshaft for condition
and security. Examine the components as follows:
a. Driveshaft for cracks, corrosion, and surface damage.
b. Flexframe and bolts for condition and signs of slippage.
Chapter 96 ELECTRICAL
1. Examine all electrical components, wires, cables and
connectors in the area of the forward deck and transmission for
chafing, general condition, and security.
GROUND RUN
GROUND RUN OF HELICOPTER TO BE
ACCOMPLISHED BY QUALIFIED PERSONNEL
ONLY.
Chapter 12 1. Make sure applicable servicing requirements have been
carried out.
2. Check oil level of transmission, hydraulic tank, engine and
rail rotor gearbox prior to running helicopter.
3. Make sure that helicopter is ready for ground run and that
surrounding area is clear.
BHT-206L4-FM-1 4. Start the helicopter and conduct ground run at 100% N
R
to
check for leaks and ensure all systems are operational and
parameters are within Flight Manual limitations.
5-16. 100-HOUR AIRFRAME PROGRESSIVE INSPECTION — EVENT NO. 1 (CONT)
DATA REFERENCE INSPECTION TASK DESCRIPTION
INITIAL
MECH OTHER
7 JUN 2013 Rev. 18 Page 25/26
To Next Page
Loading...
Need help?
General
