BHT-206L4-MM-1
5-00-00
25 FEB 2011 Rev. 13 Page 33
ECCN EAR99
5-18. 100-HOUR AIRFRAME PROGRESSIVE INSPECTION — EVENT NO. 3
DATA REFERENCE INSPECTION TASK DESCRIPTION
INITIAL
MECH OTHER
DATE: __________________W.O. _____________________
FACILITY: __________________________________________
HELICOPTER S/N: ___________________________________
REGISTRY NO.: _____________________________________
TOTAL TIME:_______________________________________
SIGNATURE:________________________________________
ZONE 6 — TAILBOOM
Chapter 11 PLACARDS AND MARKINGS
1. Examine the placards, decals and markings. Ensure they
are readable, correctly applied and in agreement with the
applicable configuration of your helicopter.
TAILBOOM STRUCTURE
Chapter 53 1. Remove and examine tail rotor driveshaft cover, and
fasteners for condition and security.
2. Remove and examine tail rotor gearbox fairings for
condition.
3. Examine anti-chafing adhesive tape (C-460) on tailboom
for condition. Replace worn or damaged tape as required.
In the event that cracks are found, contact Bell
Helicopter Textron, Product Support Engineering.
4. Examine entire tailboom for the following conditions:
a. Dents.
To Next Page
Loading...
Need help?
General
