BHT-206L4-MM-1
5-00-00
Page 74 Rev. 20 7 NOV 2014 Export Classification C, ECCN EAR99
Chapter 96 and
Chapter 97
ELECTRICAL AND AVIONICS
1. Examine all visible electrical components, wires, cables,
and connectors in the area of the forward fuselage for chafing,
and general condition and security.
2. Remove battery and recondition in accordance with
BHT-ALL-SPM and manufacturer’s service manual.
3. Examine battery vent tubes for obstruction or damage.
4. Perform operational test of the battery temperature
indicating system.
5. If battery was removed, clean mounting area prior to
installing serviceable battery.
6. Verify operation of litter door open warning light.
7. Verify operation of landing lights.
8. Verify operation of lower fuselage mounted position lights
(if installed).
9. Examine antennas for condition and security.
GROUND RUN
GROUND RUN OF HELICOPTER TO BE
ACCOMPLISHED BY QUALIFIED PERSONNEL
ONLY.
Chapter 12 1. Make sure applicable servicing requirements have been
carried out.
2. Check oil level of transmission, hydraulic tank, engine and
rail rotor gearbox prior to running helicopter.
5-25. 300-HOUR AIRFRAME PROGRESSIVE INSPECTION — EVENT NO. 5 (CONT)
DATA REFERENCE INSPECTION TASK DESCRIPTION
INITIAL
MECH OTHER
To Next Page
Loading...
Need help?
General
