BHT-206L4-MM-1
5-00-00
25 FEB 2011 Rev. 13 Page 43
ECCN EAR99
3. Examine all optional equipment installed in the aft fuselage
area for condition and security.
4. Verify proper operation of fuel sump drain valve switch.
ZONE 10 — LANDING GEAR
Chapter 11 PLACARDS AND MARKINGS
1. Examine the placards, decals and markings. Ensure they
are readable, correctly applied and in agreement with the
applicable configuration of your helicopter.
Chapter 32 CROSSTUBES
1. Examine crosstube retaining straps, cushions, and
attaching hardware for condition and security.
2. Examine fuselage attachment fittings for condition and
security.
3. Examine electrical bonding strips (if installed) for condition
and security.
4. Examine fairings (if installed) for condition and security.
5. Examine crosstube riveted or clamped supports for
condition and security. Give particular attention to the sealant
joints around supports. Restore sealant (C-251) and paint finish
as required.
6. Examine crosstubes for corrosion and damage. Give
particular attention to areas where equipment is mounted.
Repair and/or restore surface protection as required.
7. Examine cabin entry steps for condition and security (if
installed).
8. Examine sealant joint at junction with skid tube saddles.
Restore sealant (C-251) and paint finish as required.
Chapter 32 SKID TUBES
1. Examine skid tubes for corrosion, damage, and security.
5-19. 100-HOUR AIRFRAME PROGRESSIVE INSPECTION — EVENT NO. 4 (CONT)
DATA REFERENCE INSPECTION TASK DESCRIPTION
INITIAL
MECH OTHER
To Next Page
Loading...
Need help?
General
