Bematech BR200BT - Setting Pin Code; Deleting Pin Code; Reset Name

Handy Wireless Scanner
22
USER MANUAL
Start Of Configuration
Setting Pin Code
1. To change the pin code, use the “Set pin code” setting. Default is “12345678”.
2. Use the ASCII table in Programming Guide to input the new code (must be at
least 4 digits and not more than 8 numeric digits).
3. Scan “Save Setting” to store the pin code.
Set pin code
Set pin code (SPP Master only)
Confirm Setting (for address and pin code setting
required)
Please check the User Manual from your PC for wireless address and pin code.
Deleting pin code
To delete pin code, use the “Delete pin code setting”.
Delete pin code
Delete the stored pin code.
Reset Name
To change the scanner name back to the default name “BR200BT” use the “Default
device name” setting.
Default device name
Change device name back to default “BR200BT”.
End Of Configuration