EasyManuals Logo

Bematech BR200BT User Manual

Bematech BR200BT
89 pages
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #89 background imageLoading...
Page #89 background image
Handy Wireless Scanner
79
USER MANUAL
Appendix 2: Barcode Length Setting
Introduction
The length of a barcode is the number of characters it contains, including check digits.
As listed in the Default Parameters section, each barcode type has different default
length. You may change the setting by the following procedure.
To set up barcode length, the paramours to be determined are barcode type and the
desired barcode length. Barcode length is consisted of 2 digits. For numbers smaller
than 10, you need to add a “0” in the front.
Example
If the barcode length is 4 to 12 digits, the steps would be as below:
Start of Configuration
Set up minimum
barcode length
Set up maximum
barcode length
End of Configuration
Use the ASCII table (Appendix 4) to set up barcode length. Be sure to enable
the full ASCII code 39 option before you start and read the “Set” label to set
your choice into memory.
Start
Set up barcode length
End
Scan the “Start of
configuration” barcode
Scan the
Min barcode
Set theMax
barcode
Scan the “Set
barcode to save this
setting
Set up the
second digit: 2
Scan the first
digit: 0
Set up the first
digit: 1
Scan the second
digit: 4
Read the “Full ASCII
code 39” barcode
Turn to the page of the
barcode type to be set
up
Scan the “End of
configuration
barcode

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Bematech BR200BT and is the answer not in the manual?

Bematech BR200BT Specifications

General IconGeneral
Battery voltage3.7 V
Battery capacity850 mAh
Power source typeBattery
TypeHandheld bar code reader
Wavelength617 nm
Sensor typeCCD
Scanner type1D
Read rate (max)330 reads/s
Light levels (direct sunlight)0 - 100000 lx
Linear (1D) barcodes supportedCodabar, Code 128, Code 32, Code 39, Code 93, ITF-14, JAN, U.P.C.
2D (matrix & stacked) barcodes supportedNot supported
Standard interfacesBluetooth
Connectivity technologyWireless
Product colorBlack
LED indicatorsYes
Housing material-
International Protection (IP) codeIP43
Storage temperature (T-T)-10 - 60 °C
Operating temperature (T-T)0 - 50 °C
Operating relative humidity (H-H)5 - 95 %
Weight and Dimensions IconWeight and Dimensions
Depth62 mm
Width147 mm
Height114.5 mm
Weight210 g