Technical data
61
isoEV425_D00126_09_M_XXEN/03.2019
Classification of mechanical conditions acc. to IEC 60721
Stationary use (IEC 60721-3-3) .............................................................................................................................. 3M4
Transport (IEC 60721-3-2) ..................................................................................................................................... 2M4
Long-term storage (IEC 60721-3-1) .................................................................................................................... 1M12
Connection
Connection type.........................................................................................screw-type terminal or push-wire terminal
Screw-type terminals:
Nominal current....................................................................................................................................................≤ 10 A
Tightening torque...............................................................................................................0.5…0.6 Nm (5…7 lb-in)
Conductor sizes............................................................................................................................................. AWG 24-12
Stripping length ......................................................................................................................................................8 mm
Rigid/flexible........................................................................................................................................... 0.2…2.5 mm
2
Flexible with ferrules with/without plastic sleeve .............................................................................. 0.25…2.5 mm
2
Multi-conductor rigid............................................................................................................................ 0.2…1.5 mm
2
Multi-conductor flexible.........................................................................................................................0.2…1.5 mm
2
Multi-conductor flexible with ferrules without plastic sleeve ............................................................0.25…1.5 mm
2
Multi-conductor flexible with TWIN ferrules with plastic sleeve..........................................................0.5…1.5 mm
2
Push-wire terminals:
Nominal current....................................................................................................................................................≤ 10 A
Conductor sizes............................................................................................................................................. AWG 24-14
Stripping length ....................................................................................................................................................10 mm
Rigid ........................................................................................................................................................0.2…2.5 mm
2
Flexible without ferrules....................................................................................................................... 0.75…2.5 mm
2
Flexible with ferrules with/without plastic sleeve .............................................................................. 0.25…2.5 mm
2
Multi-conductor flexible with TWIN ferrules with plastic sleeve..........................................................0.5…1.5 mm
2
Opening force ........................................................................................................................................................... 50 N
Test opening, diameter .......................................................................................................................................2.1 mm
Wiring of the terminals Up, AK1, GND, AK2 ......... refer to technical data AGH420 under the heading "Connection"
To Next Page
Loading...
Need help?
General
