Bender ISOMETER isoPV425 - Standards, Approvals and Certifications

Technical data
64
isoPV425_D00028_09_M_XXEN/05.2018
Cable lengths...................................................................................................................................................... ≤ 0.5 m
Connection properties ....................................................................................... ≥
0.75 mm
2
Other
Operating mode ...........................................................................................................................Continuous operation
Mounting ..................................................................................................... cooling slots must be ventilated vertically
Distance to adjacent devices from U
n
> 800 V ............................................................... ≥ 30 mm
Degree of protection internal components (DIN EN 60529) .................................................................................. IP30
Degree of protection terminals (DIN EN 60529) ..................................................................................................... IP20
Enclosure material ....................................................................................................................................polycarbonate
DIN rail mounting acc. to.................................................................................................................................IEC 60715
Screw mounting....................................................................................................................2 x M4 with mounting clip
Weight ................................................................................................................................................................≤ 150 g
10.2 Standards, approvals and certifications
The ISOMETER® has been developed in compliance with the following stand-
ards:
 DIN EN 61557-8 (VDE 0413-8): 2015-12/Ber1: 2016-12
 IEC 61557-8: 2014/COR1: 2016
Subject to change! The specified standards take into account the edition valid
until 05.2018 unless otherwise indicated.