Bender RCMB300 Series - Page 56

Technical data
56
RCMB300-series_D00372_01_M_XXEN/06.2019
Connection
Required terminals are included in the scope of delivery
Terminal block 1
Manufacturer .............................................................................................................Phoenix Contact
Type .................................................................................................................DFMC 1.5/5-ST-3.5 BK
The connection conditions of the manufacturer apply.
Connection properties
rigid..................................................................................................0.2…1.5 mm² (AWG 24…16)
flexible .............................................................................................0.2…1.5 mm² (AWG 24…16)
with ferrules ................................................................................0.25…0.75 mm² (AWG 24…19)
Terminal block 2, 3
Manufacturer .............................................................................................................Phoenix Contact
Type .................................................................................................................FKCVW 2.5/ 3-ST-5.08
The connection conditions of the manufacturer apply.
Connection properties
rigid..................................................................................................0.2…2.5 mm² (AWG 24…13)
flexible .............................................................................................0.2…2.5 mm² (AWG 24…13)
with ferrules ..................................................................................0.25…2.5 mm² (AWG 24…13)
Mounting CTBC…
Screw type
CTBC20…60(P).............................................................................................. DIN EN ISO 7045 - M5
CTCB120…210(P) ..........................................................................................DIN EN ISO 7045 - M6
Washer type
CTBC20…60(P)........................................................................................ DIN EN ISO 7089/7090 - 5
CTCB120…210(P) ................................................................................... DIN EN ISO 7089/7090 - 6
Tightening torque
CTBC20…35 (P)...................................................................................................................... 0.6 Nm
CTCB60…210(P) ....................................................................................................................... 1 Nm
Other
Operating mode .......................................................................................................continuous operation
Mounting ............................................................................................................................... any position
Degree of protection, internal components (DIN EN 60529)..............................................................IP40
Degree of protection, terminals (DIN EN 60529).................................................................................IP20
Flammability class....................................................................................................................... UL94 V-0
Software............................................................................................................................................ D0610