8
IMPORTANT NOTE:
It is important to locate the POWER-SIDE runway (with cylinder) on the SAME SIDE as the power
unit. Rolling Jack / Utility rails on the side of each runway MUST be installed to the inside, facing
each other.
When removing the Lift from shipping angles pay close attention as the
runways can slide and can cause injury. Prior to removing the bolts make sure the runways are
held securely by a forkLift or some other heavy Lifting device.
Small Window
Large Window
Cross Tube
Small Window
Carriage
Power Side
Runway
Power Unit
Mounting Plate
Off Side
Runway
To Next Page
Loading...
