HD-973P Series Multi-Level Parking Lift 68 P/N 5900076 — Rev. B3 — January 2024
Installing the Anti-Slip Tape
The Anti-Slip Tape (SKU 5930195) is provided in two rolls measuring 6 in. x 24 ft. (152 mm x 7.3m).
BendPak suggests cutting the Tape into eight equal lengths 72 in (1,829 mm) long each.
IMPORTANT! Surface preparation is important. If the runway is in poor condition
with gouges, holes, or jagged edges the Anti-Slip Tape will not
adhere. Lift Runways must be clean, dry, and smooth.
To apply the Anti-Slip Tape:
Clean the runway. Use a broom or brush to remove loose dirt and debris from the runway.
Thoroughly wash, rinse, and dry the runway using a mild solution of soap and clean water to
remove any oils, grease, and water-soluble contamination. Dry the runway with a clean cloth and
allow to air dry.
Cut the Anti-Slip Tape into eight equal pieces. Suggested length is 72 in. (1,829 mm).
Verify the Runway is dry and clean. It is critical for maximum adhesion of the Anti-Slip Tape that the
runway be dry, free of dirt, oils, and grease.
Measure and mark the runways with pencil guide lines to outline the tape installation area on the
ramp. Refer to the figure below for a suggested layout of the Anti-Slip Tape.
IMPORTANT! Do not install this Tape directly on the edge of a Runway. Stay at least 1 in (25 mm)
away from edges. Do not attempt to bend this Tape over an edge.
Wash your hands. The Anti-Slip Tape’s adhesive side is protected by a paper or plastic film. You
will remove this film a few inches at a time to apply the Tape to the Runway.
IMPORTANT! Handle the tape by its edges. Minimize contact between the adhesive and your
hands. The oils from your hands will reduce the adhesive’s long-term effectiveness.
IMPORTANT! BendPak recommends two people work together to install the Tape. One person
removes the backing and applies the Tape to the Runway while the second holds
the Tape in place over the guide lines marked on the Runway.
Lay one piece of the Anti-Slip Tape on the runway and peel back about 2 inches (50 mm) of the
protective film. Apply the adhesive side to the Runway, inside the guide lines you created in step 5.
To Next Page
Loading...
