TRANSMISSION CHAIN AND SWING ARM
4
99
CHAS
SWING ARM REMOVAL
Park:
• the bike levelled
WARNING
Place the bike on a trestle of adequate support so
that the bike does not fall and the rear wheel is
lifted.
NOTE:
To remove the articulated connecting rods fixing
screws and the lower screw of the rear shock
absorber set hold the swing arm to avoid it falling.
NOTE:
The shock absorber must be dismantled.
1
Disconnect:
• the nuts
• the articulated connecting rods fixing screws
• the two articulated connecting rods
• the washers
• the lower screw of the rear shock absorber set
• the relative nut
2
B
B
C
A
C
Check:
• the swing arm vertical movement
by moving it up and down.
If the vertical movement of the swing arm is not
smooth or is blocked, check the spacers, the bearings,
the washers and the dust seal lids.
3
3
F
2
B
D
E
F
A
E
F
F
D
D
To Next Page