12
Notes on remote controller operation
• Some environment factor may hamper the operation of remote controller. If so, point remote controller at the
projector and repeat the operation again.
• In case the effective range of the remote controller is shortened or stops functioning, please replace the battery
with a new one.
• The projector enters wired control mode automatically and cannot be controlled by the remote controller’s IR
signal, once the cable terminal of a remote controller is inserted in the projector’s wired control port. To control
the projector with the IR signal of the remote controller again, remove the wire control terminal from the
projector.
• IR signal may be interrupted and rendered useless when the remote controller is exposed to bright sunlight or
uorescentlight.MakesuretheinstallationenvironmentisproperforIRremotecontroller.
Remote control operation
• Make sure that there is nothing positioned between the remote control and the infrared (IR)
sensors on the projector that might obstruct the IR beam from the remote control reaching the
projector.
• The effective range of the remote control is up to 7 meters, and at an angle within 30 degreesof
theIRbeam.Alwaysaimstraightattheprojector,howevermostscreenswillalsoreecttheIR
beam to the projector.
Caution:
DO NOT expose your remote controller to high temperatures or moisture or it may function abnormally.
Setup and Operation
To Next Page
Loading...
