Basic operations
21
Basic operations
Turning the display on or off
1. Be sure to follow the instruction of Connecting power on 17.
2. At the back of the display, flip on the power switch located on the lower left side to
On.The system will enter standby mode.
• To turn on the display, press the power button on the control panel or on the remote
control.
• To turn off the display, press the power button on the control panel or on the remote
control. The system will automatically enter standby mode.
Signal receiver
Power button
The display’s standby mode still consumes power. To completely cut off power supply, set the
power switch to OFF (O) and then disconnect the power cord from the power outlet.
To Next Page
Loading...
