Maintenance
60
The lamp modes are defined as the chart below.
Setting Auto Off
This function allows the projector to turn off automatically if no input source is detected
after a set period of time to prevent unnecessary waste of lamp life.
To s e t Auto Off, go into the Advanced menu > System Setup: Basic > Auto
Off menu and press / . The time period can be set from 5 to 30 minutes in 5-
minute increments. If the preset time lengths are not suitable for your presentation,
select Disable. The projector will not automatically shut down in a certain time
period.
Lamp Power Description
Normal Provides full lamp brightness
Economic
Lowers brightness to extend the lamp life and decreases the
fan noise
SmartEco
Adjusts the lamp power automatically depending on the
content brightness level
To Next Page
Loading...
